(Operating)   (Software)  

SX-2000 Series

VP-2421 Power Amplifier

The VP-2421 Power Amplifier features a 420 W-by-1 channels configuration, and uses the VP-200VX Power Amplifier Module per channel.


RCP-1000-24 External Power Supply

Features:

  • Universal AC input / Full Range
  • Protections: Short circuit / overload / over voltage / over temperature
  • Forced air cooling by built-in DC fan with fan speed control
  • Low profile: 1 unit height
  • Hot-swap operation
  • AC OK & DC OK signal


VP-200VX Power Amplifier Input Module

The VP-200VX Power Amplifier Input Module is designed to be used in conjunction with the VP-2064, VP-2122, VP-2241 or VP-2421 power amplifier.

SX-2000 Brochure 


RCP-1UI

SX power supply rack kits. Holds three RCP-1000-24.


SX-200IP IP Interface Module

Installed in the SX-2100AI Audio Input Unit of the SX-2000 Series and connected to a network (LAN or WAN), the SX-200IP allows paging announcements to be made to the SX-2000 system from the N-8000 Series station(s) (N-8600MS and N-8610RM) employing the packet audio technology.

 


SX-200RM Remote Microphone Interface Module

The SX-200RM is a dedicated remote microphone module for the SX-2000 Series audio input unit and can be used to connect two remote microphones. Input sensitivity can be adjusted using the knobs located near the RJ45 connector.


RM-200RJ Terminal Unit

The RM-200RJ is designed to convert the RJ45 connector into a screw terminal block. It is used to connect between a trunk cable (such as CPEV cable) and a feeder cable (such as LAN cable) in wiring a remote microphone. The built-in indicator shows the voltage status of DC power cable when the remote microphone cable for the SX-2000 series system is connected.

 


D-921E Mic/Line Input Module

The D-921E is a 2-channel microphone/line input module designed for use with the D-901 Digital Mixer, etc. It is equipped with removable terminal block type connectors. Input sensitivity and phantom power setting can be performed at the main frame such as the D-901.


D-921F Mic/Line Input Module

The D-921F is a 2-channel microphone/line input module designed for use with the D-901 Digital Mixer, etc. It is equipped with XLR connectors. Input sensitivity and phantom power setting can be performed at the main frame such as the D-901.


D-922E Mic/Line Input Module

The D-922E is a 2-channel microphone/line input module designed for use with the D-901 Digital Mixer, etc. It is equipped with removable terminal block type connectors. The D-901's 4-pole DIP switch is used to set the input sensitivity, phantom power supply, and ground lifting.


D-922F Mic/Line Input Module

The D-922F is a 2-channel microphone/line input module designed for use with the D-901 Digital Mixer, etc. It is equipped with XLR connectors. The D-901's 4-pole DIP switch is used to set the input sensitivity, phantom power supply, and ground lifting.


D-936R Stereo Select Input Module

The D-936R is a 4 stereo input module designed for use with the D-901 Digital Mixer, etc. It is equipped with standard RCA pin jacks. The D-936R features two stereo transmission modes: 1)Selection of one of the four stereo inputs for transmission to the D-901. 2)Mixing of all four stereo inputs, transmitting the mixed signal to the D-901 through left/right channel outputs. Mode settings and stereo selection are performed at the main frame such as the D-901.